Tubular conveyor （Pipe belt conveyor） is a new type of bulk material conveying equipment. The application of tubular conveyors is basically unconstrained. Any material can be selected for conveying. Typical materials for conveying are: ore, coal coke, limestone, crushed stone, shale and alluvial soil. Some materials that are very difficult to handle, such as steel concentrates, petroleum coke, cla...

How to install a complete conveyor system, SKE advise you the safety specification while installing conveyors;The safety specifications of the conveyor system are as follows:(1) The equipment on the transmission line must be interlocked, and the interlocking device must not be changed or removed at will.(2) When multiple conveyors are used to transport materials or a certain process, a centralized...

As one of the important components of belt conveyor, the belt’s life and quality almost directly determine the life of the belt conveyor and whether the conveyors can run smoothly and smoothly.Generally, the common methods of conveyor belt joints are mechanical joints, cold bonding joints, thermal vulcanized joints, etc. It is especially important to choose a suitable method of conveyor belt joint...

Q: What causes conveyor belt longitudinal tear?A: There are serious deformation and damage on the conveyor belt joint.1)A large piece of material or iron is stuck in the conveyor belt.2)The conveyor belt deviates and the anti tearing device fails.3)There are sundries involved in the roller (pulley) between the conveyor belts.4)The wedge on the rope clamp is not tightened.Q:Harm of longitudinal tea...

Different type idlers of model for different application:Ordinary idler: grain, loading and transportationTrough idler: coal, cement, power，aggregatesGroove type self-aligning idler: smelting metal,Mine, electric power, cement, chemical industry, building materials, steel plant, transportation equipment.Ground roller: applicable to mining industryStop roll, vertical roll: belt conveyorSuspend idle...

Precautions for installation and commissioning1, Precautions during belt conveyor installation1). All rollers, idlers and driving devices shall rotate evenly and flexibly after installation;). During the test operation, if the belt deviates, adjust the mounting point or frame of E-pin to adjust the deviation;2, Test operation shall be carried out after installation1). Two hours of no-load and eigh...

① check whether the oil level and quality of the reducer are normal;② check whether the idler inside the belt and the head and tail rollers are caked, and whether there is any accumulated material on the ground that hinders the operation of the belt, which should be cleaned in time; ③ confirm whether the cleaner is adjusted to a proper position; ④ check whether the idler is missing, and whether th...

Q:What reasons caused the Spreading of belt conveyor and how to solve it? A: There are some spreading points in conveyor while in operation 1.Spread the material at the load point. Spreading material at the transfer point is mainly in the falling hopper, material guide slot,...

Maintenance and instructions of Normal conveyor belt Q: How to store and maintain the spared belt conveyor?A: 1. Conveyor belts should be kept clean during transportation and storage to avoid exposure to sunlight or rain or snow, to prevent contact with acids, a...

Belt conveyor safety operation regulations 1. Wear labor protection equipment properly before operation.2. The equipment must be fully inspected before starting up, remove obstacles, and start the operation before making sure that no one standing on the head, ta...

Causes and hazards of Conveyor belt deviation The belt is the most important part of the belt conveyor. Whether the belt runs smoothly has a great impact on the mechanical capacity, efficiency and life. When the belt conveyor runs, the deviation of the belt is ...

The reasons caused and the methods to solve out the problem of motor There are five reasons why the motor can't be started or slows down immediately after starting, which are:(1) line fault; (2) locking of protection electric control system; (3) improper install...